Question 1

When does concrete achieve its design strength after casting?

Accepted Answer

Concrete achieves its design strength and stiffness 14 to 28 days after casting. During this period, the hydration process continues as cement dissolves in water, forming crystals that give the material its final structure. Test cylinders cast at the same time as placement are tested to verify the concrete meets strength requirements.

Question 2

What factors affect the strength of cured concrete?

Accepted Answer

Concrete strength is affected by the mixed design, curing temperature and humidity, and uniformity of the product. Additionally, temperature and humidity during storage, specimen condition during testing, and the testing procedure itself all influence results and must be carefully controlled to ensure accurate strength measurements.

Question 3

How is Young's modulus determined in concrete compression testing?

Accepted Answer

A device called a compressometer is attached to the test specimen to measure longitudinal and hoop deformations at specific load increments. By recording these deformations using dial indicators at loads up to 60,000 pounds, engineers can calculate Young's modulus and Poisson's ratio, which describe the material's elasticity and stress-strain behavior.

Question 4

What does the failure pattern of concrete cylinders reveal about the failure mechanism?

Accepted Answer

Concrete cylinders typically fail along an inclined plane at roughly 45 degrees, indicating that failure is driven by shear forces and splitting tension stresses rather than pure compression crushing. This failure mode reveals the complex stress state within the material during compression testing.

Question 5

How does the Schmidt hammer test evaluate concrete strength in place?

Accepted Answer

The Schmidt hammer shoots a steel weight at the concrete surface and measures the rebound distance, which correlates to material strength. Measurements are taken across a grid pattern on the surface, and the average rebound number is related to in-situ strength through calibration with laboratory cylinder tests.

Question 6

What preparation steps are required before testing a concrete cylinder in compression?

Accepted Answer

Remove the concrete cylinder from the mold and dry its surface. Inspect the cylinder and use a file to remove major surface imperfections from its ends. Apply a neoprene cap to each end to ensure they are flat and level, then center the specimen in the hydraulic testing machine before applying load.

Question 7

Why is in-situ concrete testing used alongside laboratory cylinder tests?

Accepted Answer

While cylinder tests determine the strength of concrete delivered to the site, in-situ testing evaluates quality in place over the structure's lifespan. Non-destructive methods like the Schmidt hammer allow engineers to assess concrete consistency across multiple surfaces without damaging the structure, providing ongoing quality assurance.

경화 콘크리트 대상 압축 테스트

Browse More Videos